Once it reaches 100%, you will hear a USB unplugged sound from your computer, wait for it to automatically connect back again.ĥ. Look for and select the file 'H502S-FC-V1.1.31.hbs'. As soon as the bottom of the upgrade tool shows 'connected', click Open File. Open the rear hatch of your drone and find the little port- connect your drone to the computer with this port and the cord (no need to connect battery to the drone).Ģ. You will need: an Android Mini USB and a Type A to Mini B USB.ġ) Make sure you have an Android mini USB cord ready. This will help the tools and firmware downloads run on your computer. Select and run the file inside the folder DVRSETUP64. Keep this in mind.īefore you attempt any upgrade, download and install the CH341SER driver also uploaded in the Google Drive link. The former is for the FC firmware upgrade and the latter is for RX and TX. Also notice that there are two different upgrade tools: FC Upgrade Tool V2 and Upgrade Tool V2. Even though the numbers might vary from tutorial to tutorial, you can always see if the file begins with ∿C, RX or TX/RC/HRC-FPV. You need to upgrade Flight Control (FC), Receiver (RX) and Transmitter (TX). Hubsan H501S firmware upgrade video tutorial (2 min 11 sec)īasically, there are three components to a full drone upgrade. ONLY upgrade the FC and RX for the FPV1 model. The firmware upgrade process for the high edition transmitter model is the same as listed below.

Still, this should do the job and if you have any other questions, don't hesitate to contact me or kevin_gotta_bomb. I have listed a full instructional guide below, as well as the official Hubsan upgrade video.

This package is meant to extend FPV and flight range to the H501S. It is my pleasure to introduce our new SuperFlyer firmware package. Riporto quanto indicato sul forum straniero

Ch341ser usb driver hubsan 501s